NunesMelnick83

出典: くみこみックス

The Xbox 360 console is an amazing package alone. However, with games like Cod 5, Modern Warfare, and Mw2, increasing numbers of people find top reasons to modify the said gaming console, or its accessories. One modification is a reaction to create a rapid fire modded Xbox controller. Listed here are the steps on how to modify your original controller with a rapid fire controller.

Step 1. Unscrewing the controller

Xbox 360 modded controllers - Before you begin taking your controller apart, take a close look in the controller first and attempt to remember which parts go where since you will eventually must put everything again. Begin by unscrewing all of the visible screws at the back. After this, before you tug on the case, remove the batteries to show the hidden screws. Remove these too.

Step 2. Preparing the truth

With the controller facing down, slowly and punctiliously separate the leading 50 % of the casing in the circuit board. An opening in the event could eventually need to be made. Consider this before putting things back.

Step 3. Placing The Rapid Fire Button

While other methods of modifying the controller do not involve installing of a new button, this particular guide does. Furthermore this provide help to adjust the rate of rapid fire, it minimizes tampering along with other areas of the circuit board, thereby minimizing the potential risk of damaging your modded Xbox 360 console controller.

Modded controllers - Remember, kits for that rapid fire controller can be bought easily. It's the button using this kit that'll be placed from the hole inside the casing, so put it gently prior to the circuit board is returned. You may have to snip out a couple of flaps to make method for the wires from the kit. This can be done with whether cutter or even a couple of scissors.

Step # 4. Soldering

Assuming that you are aware how to properly use a soldering iron, attach the red wire for the leftmost pin of a 4-pin horizontal series, as the blue wire solders for the rightmost pin of the same series. The black (or green in some instances) wire attaches to the center of the three vertical series right from the switch.

Soldering is regarded as the crucial step to making the modded Xbox 360 controller. The reason being mistakes made during this stage can permanently damage your controller.

Step five. Putting everything back

Xbox 360 modded controllers - Carefully being attentive to the wires, make an effort to close the circuit board and also the casing. This is usually a little tricky as the new wires will get when it comes to things. Find a way because of these wires to occupy the empty spaces as opposed to sticking out. You might support the modded Xbox 360 console controller facedown so the buttons don't fall and maneuvering the wires certainly are a little easier. Position the casings together such as the return the screws yet. Congratulations, you need to find out if the rapid fire buttons work. If they don't, you may need to restart both your console as well as the now modded Xbox 360 console controller. This will solve the issue. If it doesn't then you can have to go from the steps again to double check.