IzaguirreMcvay301

出典: くみこみックス

The Xbox 360 console has already been a fantastic package alone. However, with games like Call of Duty 5, Modern Warfare, and Mw2, increasing numbers of people find good reasons to customize the said gaming console, or its accessories. One particular modification can be a response to create a rapid fire modded Xbox 360 controller. Listed below are the steps concerning how to modify your original controller to a rapid fire controller.

The first step. Unscrewing the controller

Mod controller - Before you start taking your controller apart, take a critical look on the controller first and then try to remember which parts go where because you will eventually need to put everything again. Begin by unscrewing every one of the visible screws at the back. Next, prior to deciding to tug on the case, take away the batteries to reveal the hidden screws. Remove these also.

Step 2. Preparing the truth

With all the controller facing down, slowly and carefully separate the leading 50 % of the casing in the circuit board. An opening in the event will ultimately need to be made. Remember this before putting things back.

3. Placing The Rapid Fire Button

While other ways of modifying the controller do not involve installing a fresh button, this specific guide does. Not only does this make it easier to adjust the pace of rapid fire, it minimizes tampering with parts of the circuit board, thereby minimizing the potential risk of damaging your modded Xbox controller.

Xbox 360 modded controllers - Remember, kits for the rapid fire controller are available easily. It is the button from this kit which will be placed with the hole in the casing, so place it gently ahead of the circuit board is returned. You might want to snip out several flaps to produce method for the wires from the kit. This can be done with either a cutter or even a pair of scissors.

Step four. Soldering

Let's assume that you are aware how to properly start using a soldering iron, attach the red wire to the leftmost pin of your 4-pin horizontal series, while the blue wire solders to the rightmost pin of the series. The black (or green in some cases) wire attaches for the core three vertical series right from the switch.

Soldering is the most crucial step to making the modded Xbox controller. This is because mistakes made during this stage can permanently damage your controller.

Step five. Putting everything back

Mod controller - Carefully taking note of the wires, try to close the circuit board and also the casing. This may be a little tricky since the new wires are certain to get in the form of things. Discover a way of these wires to occupy the empty spaces instead of protruding. You might contain the modded Xbox 360 controller facedown so that the buttons don't fall and maneuvering the wires certainly are a little easier. Put the casings together try not to return the screws yet. Congratulations, you have to check if the rapid fire buttons work. Should they don't, you may need to restart both your console and also the now modded Xbox 360 controller. This will solve the issue. If it doesn't you might have to go with the steps again to check.