HarnerHefner445

出典: くみこみックス

The Xbox 360 is already a fantastic package by itself. However, with games like Cod 5, Modern Warfare, and Mw2, a lot more people find good reasons to get a new said game console, or its accessories. One such modification is really a response to produce a rapid fire modded Xbox 360 controller. Listed here are the steps on how to modify your original controller to some rapid fire controller.

The first step. Unscrewing the controller

Xbox 360 modded controllers - Prior to starting taking your controller apart, require a close look in the controller first and try to remember which parts go where since you will eventually need to put everything again. Start by unscrewing every one of the visible screws behind. Following this, before you decide to tug on the case, remove the batteries to reveal the hidden screws. Remove these also.

Step two. Preparing the situation

With all the controller facing down, slowly and thoroughly separate the leading half of the casing from your circuit board. A hole in the case will eventually should be made. Consider this before putting things back.

3. Placing The Rapid Fire Button

While other types of modifying the controller usually do not involve installation of a brand new button, this particular guide does. Besides this make it easier to adjust the pace of rapid fire, it minimizes tampering along with other elements of the circuit board, thereby minimizing the risk of damaging your modded Xbox controller.

Xbox 360 modded controllers - Remember, kits for your rapid fire controller are available easily. Oahu is the button out of this kit that will be placed through the hole in the casing, so stick it gently prior to the circuit board is returned. You might need to snip out a couple of flaps to make method for the wires from the kit. You can do this with the cutter or a set of scissors.

Step # 4. Soldering

Let's assume that you know how to correctly use a soldering iron, attach the red wire to the leftmost pin of a 4-pin horizontal series, even though the blue wire solders to the rightmost pin of the series. The black (or green sometimes) wire attaches towards the center of the three vertical series off to the right with the switch.

Soldering is regarded as the crucial step to making the modded Xbox 360 controller. This is because mistakes made with this stage can permanently damage your controller.

Step # 5. Putting everything back

Xbox 360 modded controllers - Carefully considering the wires, attempt to close the circuit board and the casing. This is usually a little tricky as the new wires are certain to get in the form of things. Discover a way of these wires to occupy the empty spaces as opposed to herniated. You may hold the modded Xbox 360 console controller facedown so that the buttons don't fall and maneuvering the wires really are a little easier. Position the casings together try not to return the screws yet. You now need to see if the rapid fire buttons work. Should they don't, you may have to restart both your console and the now modded Xbox controller. This should solve the situation. Whether it doesn't you might will need to go with the steps again to make sure.