FriedmanBee140

出典: くみこみックス

The Xbox is already an incredible package by itself. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, a lot more people find good reasons to customize the said video game console, or its accessories. One modification is a reaction to develop a rapid fire modded Xbox controller. Listed here are the steps regarding how to modify your original controller to some rapid fire controller.

Step 1. Unscrewing the controller

Mod controller - Prior to starting taking your controller apart, have a critical look in the controller first and attempt to remember which parts go where since you will eventually need to put everything rear. Start by unscrewing every one of the visible screws at the back. Following this, before you tug on the case, take away the batteries to reveal the hidden screws. Remove these also.

Step two. Preparing the situation

With all the controller facing down, slowly and carefully separate the leading 50 % of the casing in the circuit board. A hole in the event will eventually should be made. Don't forget this before putting things back.

Step 3. Placing The Rapid Fire Button

While other methods of modifying the controller don't involve installing of a new button, this kind of guide does. Furthermore this help you to adjust the rate of rapid fire, it minimizes tampering with elements of the circuit board, thereby minimizing the chance of damaging your modded Xbox controller.

Modded controllers - Remember, kits for your rapid fire controller can be purchased easily. It is the button out of this kit that will be placed through the hole inside the casing, so stick it gently ahead of the circuit board is returned. You might want to snip out a couple of flaps to create method for the wires from the kit. You can do this with either a cutter or perhaps a set of scissors.

Step 4. Soldering

If you are aware how to correctly utilize a soldering iron, attach the red wire to the leftmost pin of your 4-pin horizontal series, even though the blue wire solders for the rightmost pin of the series. The black (or green in some instances) wire attaches for the center of the three vertical series to the right of the switch.

Soldering is regarded as the crucial key to making the modded Xbox 360 console controller. This is because mistakes made in this stage can permanently damage your controller.

Step five. Putting everything back

Xbox 360 modded controllers - Carefully taking note of the wires, make an effort to close the circuit board as well as the casing. This may be a little tricky because the new wires will get in the form of things. Discover a way of these wires to occupy the empty spaces instead of herniated. You could contain the modded Xbox controller facedown so the buttons don't fall and maneuvering the wires really are a little easier. Position the casings together such as the return the screws yet. You now have to check if the rapid fire buttons work. If they don't, you may need to restart both your console and the now modded Xbox controller. This will solve the situation. When it doesn't then you may have to go from the steps again to double check.