利用者:LambSnow693

出典: くみこみックス

The Xbox 360 console is a fantastic package by itself. However, with games like Call of Duty 5, Modern Warfare, and Mw2, increasing numbers of people find top reasons to modify the said game console, or its accessories. One particular modification can be a reply to produce a rapid fire modded Xbox 360 controller. Listed below are the steps regarding how to modify your original controller with a rapid fire controller.

The first step. Unscrewing the controller

Modded controllers - Before you begin taking your controller apart, require a close look in the controller first and then try to remember which parts go where because you will eventually have to put everything back again. Begin by unscrewing all of the visible screws in the dust. Following this, before you tug involved, take away the batteries to reveal the hidden screws. Remove these too.

Step two. Preparing the truth

Using the controller facing down, slowly and carefully separate the front 1 / 2 of the casing from the circuit board. A dent in case will eventually should be made. Don't forget this before putting things back.

Step three. Placing The Rapid Fire Button

While other methods of modifying the controller don't involve installing of a fresh button, this particular guide does. Furthermore this help you to adjust the pace of rapid fire, it minimizes tampering with areas of the circuit board, thereby minimizing the chance of damaging your modded Xbox 360 console controller.

Xbox 360 modded controllers - Remember, kits for your rapid fire controller can be bought easily. It's the button out of this kit that'll be placed from the hole in the casing, so put it gently before the circuit board is returned. You might want to snip out a couple of flaps to make method for the wires of the kit. This can be achieved with whether cutter or even a set of scissors.

Step # 4. Soldering

Assuming that you know how to properly utilize a soldering iron, attach the red wire towards the leftmost pin of the 4-pin horizontal series, even though the blue wire solders towards the rightmost pin of the identical series. The black (or green in some instances) wire attaches towards the middle of the three vertical series off to the right with the switch.

Soldering is regarded as the crucial key to making the modded Xbox 360 console controller. It is because mistakes made in this stage can permanently damage your controller.

Step 5. Putting everything back

Xbox 360 modded controllers - Carefully considering the wires, attempt to close the circuit board and the casing. Pest little tricky because the new wires can get when it comes to things. Find a way of these wires to occupy the empty spaces rather than herniated. You could contain the modded Xbox 360 controller facedown so the buttons don't fall and maneuvering the wires certainly are a little easier. Put the casings together such as the return the screws yet. Congratulations, you need to see if the rapid fire buttons work. Should they don't, you may want to restart both your console and the now modded Xbox 360 controller. This will solve the issue. When it doesn't you might need to go with the steps again to double check.