EstrellaMontanez542

出典: くみこみックス

2012年9月12日 (水) 17:06; EstrellaMontanez542 (会話 | 投稿記録) による版
(差分) ←前の版 | 最新版を表示 (差分) | 次の版→ (差分)

The Xbox is a fantastic package in itself. However, with games like Call of Duty 5, Modern Warfare, and Modern Warfare 2, increasing numbers of people find reasons to customize the said game console, or its accessories. One particular modification is a reaction to create a rapid fire modded Xbox 360 console controller. Here are the steps on how to modify your original controller to a rapid fire controller.

Step one. Unscrewing the controller

Modded controllers - Before you begin taking your controller apart, have a critical look on the controller first and attempt to remember which parts go where because you will eventually must put everything rear. Start with unscrewing all the visible screws behind. Following this, before you tug on the case, eliminate the batteries to show the hidden screws. Remove these too.

Step 2. Preparing the situation

With all the controller facing down, slowly and punctiliously separate leading 50 % of the casing from the circuit board. A dent in case will ultimately need to be made. Don't forget this before putting things back.

Step 3. Placing The Rapid Fire Button

While other types of modifying the controller do not involve installation of a new button, this particular guide does. Besides this make it easier to adjust the speed of rapid fire, it minimizes tampering along with other elements of the circuit board, thereby minimizing the chance of damaging your modded Xbox 360 console controller.

Mod controller - Remember, kits for your rapid fire controller can be purchased easily. It is the button from this kit which will be placed with the hole inside the casing, so stick it gently before the circuit board is returned. You may have to snip out several flaps to create method for the wires from the kit. This can be achieved with the cutter or even a couple of scissors.

Step 4. Soldering

Let's assume that you are aware how to correctly use a soldering iron, attach the red wire to the leftmost pin of your 4-pin horizontal series, as the blue wire solders towards the rightmost pin of the same series. The black (or green sometimes) wire attaches towards the middle of the three vertical series to the right of the switch.

Soldering is the most crucial step to making the modded Xbox 360 controller. It is because mistakes made during this stage can permanently damage your controller.

Step five. Putting everything back

Xbox 360 modded controllers - Carefully taking note of the wires, try to close the circuit board as well as the casing. This is usually a little tricky as the new wires are certain to get in the form of things. Discover a way of these wires to occupy the empty spaces instead of herniated. You might hold the modded Xbox 360 console controller facedown so the buttons don't fall and maneuvering the wires are a little easier. Put the casings together try not to return the screws yet. At this point you need to see if the rapid fire buttons work. Should they don't, you may want to restart both your console as well as the now modded Xbox 360 console controller. This should solve the issue. If it doesn't you might will need to go with the steps again to double check.

表示